Creality Ender-5 Max

Large CoreXY 3D printer from Creality with a 400 × 400 × 400 mm build volume, up to 700 mm/s, 64-point auto leveling, dual Z motors, a 1000 W heated bed and a tri-colour status light for print farms. Listed at PrototypeBD for buyers in Bangladesh. Browse more 3D printers.

Key features

64-point leveling for a large first layer

On a 400 × 400 mm plate the first layer decides whether a long print succeeds. The Ender-5 Max probes 64 points automatically and sets its own Z-offset, so it lays an even first layer without manual adjustment.

Die-cast frame, linear rail and dual Z

The frame uses enlarged die-cast aluminium parts, and the X-axis runs on a precise linear rail. The bed is carried by two independently motorised Z axes with two pairs of lead screws, each helped by two linear rods; Creality says they lift a 5 kg model without layer shifts (Creality lab data). X and Y use 42-76 stepper motors for up to 700 mm/s and 20,000 mm/s² (500 mm/s typical).

1000 W heatbed and flexible epoxy plate

A 1000 W heater warms the aluminium bed to 80 °C in about 200 seconds (Creality lab data at 25 °C), up to a maximum of 100 °C, for PLA, PETG, ABS, ASA and PA. The flexible epoxy build plate holds PLA at about 45 °C, lower than a PEI sheet, and bends to release finished prints.

Built for print farms

A red/green/yellow status light, visible from up to 10 m by Creality's figure, shows each printer's state at a glance. Creality Print groups several printers on one PC over WLAN, with tuned profiles and 40+ filament presets. Other features: auto filament load/unload, input shaping, 8 GB storage, filament run-out sensor, power loss recovery, a silent mode of ≤55 dB and a 5–40 °C operating range. The dual-gear extruder passed a 500-hour continuous test (Creality lab data). An enclosure kit and an HD camera are optional extras, sold separately.

Good for

• Print farms and production shops running parts in bulk

• Makers printing large props, housings and furniture parts in one piece

• Workshops that want 0.6 or 0.8 mm nozzles for faster large prints

What's in the box

Creality does not publish a packing list for this exact version on its US store or product page, so PrototypeBD confirms the box contents with you before payment.

Before you order

• Price: contact us for the current price. This model is listed for pre-order.

• Filament is not included. Creality does not list filament in the box. Spools shown in the photos are for illustration. See our filament range.

• Power: Creality rates the Ender-5 Max for 100–240 V AC, 50/60 Hz (1250 W) and says no manual voltage selection is needed, so it runs on Bangladesh 220 V mains. Ask us about the plug type of the unit you receive.

• The printer weighs up to 25.9 kg (31.9 kg packed) and measures 649 × 721 × 850 mm.

• The enclosure and camera shown on Creality's page are optional extras, not included. ABS and ASA print best inside the enclosure.

Prefer a bed-slinger with the same class of build size? See the Creality Ender-3 V3 Mega (420 mm). Browse all Creality printers and 3D printers.